Customer Reviews:
Showing reviews 1-5 of 16
 Buy this one! February 6, 2008
The Engineer
18 out of 18 found this review helpful
Kreg makes some good products. These work well. They fasten easily to miter slots or T-Track. They have 5" of adjustment. The pack of two comes with an additional pair of longer mounting bolts to allow both featherboards to be stacked for thicker or taller wood. Even have spacers included to space them out from the fence if needed. Look at the rest, then buy these.
wish I'd bought them years ago August 10, 2008
Owen Lloyd (Washington)
7 out of 7 found this review helpful
This is a great product and safety device. I borrowed a the Bench Dog version from a friend, but found it didn't fit tightly into my Ridgid TS3650 table saw. This Kreg model fits great and locks down tight. After using them for only a day, I can't vouch for their longterm quality yet, but I can say I found myself thinking back to how many times I've been lucky and not lost parts of my fingers because I was stupid and putting them close to the blad because I didn't have a product like this to hold the wood tight to the fence. My only regret so far is hesitating spend the $40 to buy a product that I thought wouldn't be the helpful. I should have bought them years ago and not relied on luck to keep my fingers attached.
They get the job done April 14, 2008
Matthew Krout (Philadelphia, PA)
4 out of 4 found this review helpful
I've used these for about a month now on both a table saw and router table. Had zero problems. Easy to adjust. Hold tight in the tracks. I have cut and routered thicknesses of 1/4 inch to 2 inches. Great results epecially on the router table compared with not using featherboards. Good product for the price.
Nice featherboards May 5, 2008
Engineering Geek (Orlando FL)
3 out of 3 found this review helpful
In error, I ordered two of these, not realizing that they came in a two-pack. Thus, when they arrived, there were four featherboards. OK, you can never have too many of these things, so I kept them. That turned out to be a good thing. To change these things from a right-to-left feed into a left-to-right feed, you remove the bolts and washers and put them in from the other side. My router table uses right-to-left, and my table saw uses the equivalent of left-to-right, so I have two of them set up each way. Works great. Not that expensive, and if I had used them my entire woodworking career, I wouldn't have a messed up finger from a board kicking back at me. These are as well made as any I've seen.
Best Featherboard around October 1, 2009
K. Thompson (St Pete FL)
3 out of 3 found this review helpful
I use nothing else since finding these, I have 2 sets on my router table and another pair on my table saw. 10 times better than bulldog or other brands I used to use.
Showing reviews 1-5 of 16
|
